Installation

Full directions to installing our bicycle wheel lights the proper way!

Step 1 - Insert batteries

Remove the screws from the battery pack and release the cover. Insert 3x AA batteries and secure the battery pack cover back on by tightening the 4 screws on each corner. 

Step 2 - Mount the Tube Lighting

Insert the LED tube inside the spokes on the wheel and thread it through. For best results weave the tube in and out the spokes and push the tube towards the rim until secure. Once it's secure all the way around you can overlap the remaining lights (if any) and secure it together using the cable ties.

Step 3 - Mounting the Battery Pack

Now it's time to secure the battery pack. Wrap the battery wire around the spoke to remove the slack of the wire before you begin the fasten the battery pack with cable ties. 

Mount the battery pack firstly where 2 spokes cross over each other and insert a cable tie through the hole in the battery pack and around the crossed spokes. Next thread another cable tie through the other side of the battery pack and onto another spoke that feels the most secure. Tighten both cable ties and cut off the excess. 

The battery pack should be firmly in place and unable to slide or move if mounted properly. THIS IS ESSENTIAL SO IT DOES NOT FALL OFF.

(This may vary between spoke designs, so please use your common sense when mounting it or please email us littykittyuk@gmail.com and we will be happy to assist you.